The Controller can operate 4 independent crossings It is supplied with: 8 x Red 3mm LEDs 4 x Orange 3mm LEDs 4 Black Track Reed switches 2 Magnets for Loco’s This controller detects trains approaching and leaving a level crossing. When a train is detected approaching the crossing, the lighting signal sequence is activated. First the amber LED is illuminated for 3 seconds and then the two red LED’s are flashed alternatively. The red flashing rate can be adjusted/programed as can the yellow length time/flash no. The controller can be set to use operate with 1 or 2 magnets per signal. If using 1 magnet this will be used to start the sequence, and a time period will later stop it. The time period can be programmed for different time lengths Single reed switch setups will only trigger in one direction. With 2 reed switches the first starts the crossing, with the second stopping it. Double reed switch setups will trigger in both directions. Both Amber/Yellow & Red LED durations are configurable. The amber can also be programmed to flash or even be turned off completely. The 3mm diameter LEDs have there associated resistors built into the controller board, making the wiring and fitting easier. Eight sets of lights can be controlled, each consisting of an amber and two red lights. Download Full Instruction Manual (PDF File) This product was designed by us and is still currently manufactored by us. We are therefore able to offer full technical telephone/email support if required.
Barrier/Level Crossing Signals Controller
The Controller can operate 4 independent crossings It is supplied with: 8 x Red 3mm LEDs 4 x Orange 3mm LEDs 4 Black Track Reed switches 2 Magnets for Loco’s This controller detects trains approaching and leaving a level crossing. When a train is detected approaching the crossing, the lighting signal sequence is activated. First the amber LED is illuminated for 3 seconds and then the two red LED’s are flashed alternatively. The red flashing rate can be adjusted/programed as can the yellow length time/flash no. The controller can be set to use operate with 1 or 2 magnets per signal. If using 1 magnet this will be used to start the sequence, and a time period will later stop it. The time period can be programmed for different time lengths Single reed switch setups will only trigger in one direction. With 2 reed switches the first starts the crossing, with the second stopping it. Double reed switch setups will trigger in both directions. Both Amber/Yellow & Red LED durations are configurable. The amber can also be programmed to flash or even be turned off completely. The 3mm diameter LEDs have there associated resistors built into the controller board, making the wiring and fitting easier. Eight sets of lights can be controlled, each consisting of an amber and two red lights. Download Full Instruction Manual (PDF File) This product was designed by us and is still currently manufactored by us. We are therefore able to offer full technical telephone/email support if required.
£40.80
4 in stock